Digi M10 Technical overview and Guía de instalación descargar pdf (Pagina 31)

S6 Installation Guide26

Attaching the Back Feet

To attach the Back Feet:

1 Unpack each Back Foot and screws from each Frame Chassis kit. Locate and unpack the additional Back Foot in the Side Covers

package.

2 Using a #2 Phillips screwdriver (magnetic tip recommended) and included #2 Phillips screws, attach the assembled feet to the

back of the frame. Be sure to orient them correctly before securing them to the frame.

• At the left- and right-most ends of the frame, attach the feet to the Spacer bars and adjacent Back Tie Plates as shown in

Figure 22.

Back Feet

Back Feet and

Fasteners

7020-38616-00

Back Foot, Mounting Bracket, and screws

The number of back feet is equal to the number of chassis (width) of the frame, plus one. For example, a 16-fader S6 system has

a frame width of three chassis, so it requires four back feet (3+1=4). Similarly, a 32-fader system requires six back feet (5+1=6).

Fasteners and Tools for Back Foot Mounting Bracket to chassis

Fasteners

M5x12 (7760-30554-00)

Figure 22. Attaching a Back Foot at one end of the back of the frame

If the threaded foot blocks access to the mounting screws extend the foot a few turns. See “Leveling the Chassis” on page 27.

(Not to scale)

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 81 82

Sin comentarios

Digi M10 Technical overview and Guía de instalación Pagina 31