Digi PortServer TS 8 Guia de preparacion descargar pdf (Pagina 97)

PortServer TS 8/16 Troubleshooting

17-7

For controlled TFTP access, make sure that the file /etc/tftpaccess.ctl exists and verify that it

only allows access to public directories. If this file is not present, tftp will allow full access. A

sample file is located in the directory /usr/lpp/tcpip/samples.

• Restart the inetd process with these two commands:

ps -ef | grep inetd

This will report back the inetd process number.

Kill -1 inetd_PID

Where inetd_PID is the process number for the inetd process reported by the previous command.

Resetting PortServer TS 8/16 Configuration to Defaults

Use this topic to reset the PortServer TS 8/16 configuration to defaults.

Note: This procedure causes the PortServer TS 8/16 to lose all configuration changes. If you

have a complex configuration, see the cpconf command in the Digi One/PortServer TS

Command Reference for information on backing up your configuration.

Command Line Procedure

1. Log on to the PortServer TS 8/16 as root.

2. Issue the following command:

boot action=factory

Front Panel Procedure

1. Power on the PortServer TS 8/16

2. While the PortServer TS 8/16 is still booting, press and hold (for about 10 seconds) the white

button on the front panel.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 105 106

Sin comentarios

Digi PortServer TS 8 Guia de preparacion Pagina 97