Digi PortServer TS 8 Guía de usuario descargar pdf (Pagina 52)

Chapter 11 Configuring Security Features 52

Issuing User Passwords

This section discusses how to issue user passwords.

Related Information

See the newpass and set user commands in the Digi One/PortServer TS

Command Reference.

Starting Point

This procedure assumes that you have signed on as root and already

configured the user to whom you will be issuing a password.

Procedure

1. Issue a newpass command that identifies the user (on the name field)

to whom this password will be issued.

2. When the system prompts you for a new password, type in the pass-

word and then press Enter.

3. When the system prompts you to enter the new password again, type it

in and then press Enter.

Configuring SSH Version 2 for Secure Communication

This section discusses how to configure a user for SSH version 2

encryption.

Password Protection

To configure simple password authentication for an SSH user, no SSH-

specific configuration is required. Simply configure a user by entering the

following commands:

set user name=name password=on

newpass name=name

where name is a user name

Example

set user name=ssh-user1

newpass name=ssh-user1

Using a Public Key

To enable public key authentication and to associate a public key with a

user, enter the following command:

set user name=name loadkey=host:key

where

• name is the name of a user

• host is either an IP address or DNS name of a host running TFTP

that holds

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 90 91

Sin comentarios

Digi PortServer TS 8 Guía de usuario Pagina 52