Digi CM Guía de usuario descargar pdf (Pagina 104)

Configuring Port Clustering

104 Chapter 13

Configuring Port Clustering

Assigning Master Clustering Mode

To assign a Digi CM as the master cluster device, do the following:

1. Access the Digi CM through the web interface. This Digi CM needs to be

the unit you want as the Master.

2. Under the Clustering heading, choose Configuration.

3. Choose Master from the drop down menu.

Subsequent units will be configured in Slave mode by default.

4. Choose Save & apply.

Configuring Slave Ports on the Master Unit with Auto Config

Ports on slave units are automatically enabled and set to the Telnet protocol. If

you want to disable some or all of the ports or you want to use a different

protocol, make these changes to the slave units before you autoconfigure the

slave ports on the master unit.

To configure the slave serial ports on the master unit, do the following:

1. Access the Digi CM through the web interface.

2. Under the Clustering heading, choose Configuration.

3. Select the hyperlinked letter under Unit ID or the dashed line under IP

address.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 157 158

Sin comentarios

Digi CM Guía de usuario Pagina 104