Digi CM Guía de usuario descargar pdf (Pagina 116)

Setting Date and Time

116 Chapter 14

Setting Date and Time

The Digi CM provides two options for keeping system time. The first is by

using an NTP server and the other is through an internal battery backup. To

configure the Digi CM for date and time, do the following:

1. Access the web interface.

2. System administration > Date and time.

3. To use an NTP server, choose Enable, the NTP server’s IP address, the

Time offset, and the Date and Time fields.

To use the internal battery, fill in the Date and Time fields only.

Note: If you change your time zone, you must go back and reconfigure your time for the

time zone change to be effective.

4. Choose Save & apply.

Configuring a Host Name

The system administrator can assign a Host name to the Digi CM. This is often

helpful for administration purposes to locate a specific Digi CM on the network.

To assign the Digi CM a device name, do the following:

1. Access the web interface.

2. System administration > Device name.

3. Enter the name you want to assign the Digi CM.

4. Choose Save & apply.

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 157 158

Sin comentarios

Digi CM Guía de usuario Pagina 116