Digi 9XCite-PKG Manual descargar pdf (Pagina 18)

9XCite‐PKG‐R™RS‐232/485RFModem–ProductManualv2.1[2007.01.04]

©2007MaxStream,Inc. 18

4.RFModemConfiguration

The following versions of the XCite RF Modem are available:

• 900 MHz, 9600 Baud (RF data rate), Hopping Channel Mode

• 900 MHz, 9600 Baud, Single Channel mode

• 900 MHz, 38400 Baud, Hopping Channel mode

• 900 MHz, 38400 Baud, Single Channel mode

XCite Modems can operate in both Single Channel and Hopping modes. Mode is selectable using

the "Function Set" dropdown list of the "XCite Configuration" tab of the MaxStream-provided X-

CTU Software.

The XCite Module is shipped with a unique parameter set in its memory. Parameters within the set

are organized under the following categories: AT Commands & Non-AT Settable Parameters.

4.1. Command and Parameter Types

4.1.1. AT Commands

AT Commands can be changed at any time by entering AT Command Mode and sending commands

to the modem.

AT Commands can be modified using the any of the following means:

• X-CTU Software "Modem Configuration" tab

• X-CTU Software "Terminal" tab

• Terminal software program (such as "HyperTerminal")

• Microcontroller

4.1.2. Non-AT Settable Parameters (X-CTU Software configurable only)

Non-AT Settable Parameters can only be adjusted using the MaxStream-provided X-CTU Software.

To modify Non-AT Settable Parameter, connect the module to the serial com port of a PC (interface

board is necessary for RS-232 connection) and modify parameter values through the X-CTU Soft-

ware interface. These parameters enable features that need to be set before the module is used in

the field.

Non-AT Settable Parameters can only be modified using the following means:

• X-CTU Software "Modem Configuration" tab

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 38 39

Sin comentarios

Digi 9XCite-PKG Manual Pagina 18