Digi 9XCite-PKG Manual Pagina 6

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 39
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 5
9XCitePKGR™RS232/485RFModemProductManualv2.1[2007.01.04]
©2007MaxStream,Inc.
1.3. External Interface
Figure103. DIPSwitchSettings
1-01a. Power Switch
Figure101. FrontView
Move Power Switch to the ON (up) position to power the XCite RS-
232/485 RF Modem.
1-01b. I/O & Power LEDs
LEDs indicate modem activity as follows:
Yellow (top LED) = Serial Data Out (to host)
Green (middle) = Serial Data In (from host)
Red (bottom) = Power/TX Indicator (Red light is on when
powered; it pulses on/off briefly during RF transmission.)
1-01c. DB-9 Serial Port
Standard female RS-232 (DB-9) DCE connector - Port is also used for
RS-485 and RS-422 connections.
1-01d. Power Connector*
7-18 VDC Power Connector (Center positive, 5.5/2.1 mm) - Power
can also be supplied through Pin 9 of the serial port.
1-02a. DIP Switch
Figure102. BackView DIP Switch automatically configures the XCite Module to operate in
different modes. Each time the RF modem is powered-on, intelligence
on the XIB-R interface board programs the embedded module accord-
ing to the positions of the DIP Switch. [See the figure below for DIP
Switch settings.]
In cases where AT Commands should not be sent each time the RF
Modem is powered on, the processor must be disabled by populating
J7 on the interface board. [See "Automatic DIP Switch Configura-
tions" section for more information].
1-02b. Config (Configuration) Switch
Configuration Switch provides an alternate way to enter "AT Com-
mand Mode". To enter "AT Command Mode" at the RF modem's
default baud rate, hold the Configuration Switch down while powering
on the modem using the Power Switch.
1-02c. Antenna Port
This port is a 50 Ohm RF signal connector for connecting to an RPSMA
(Reverse Polarity SMA) type antenna. The RPSMA has threads on the
outside of a barrel and a male center conductor.
101a. Power
Switch
101b. LEDs:
Yellow(top)
Green(middle)
Red(bottom)
101c. DB9
Serial Port
101d. Power
Connector
102a.DIP
Switch
102b. Configuration
Switch
102c. Antenna
Port
Vista de pagina 5
1 2 3 4 5 6 7 8 9 10 11 ... 38 39

Comentarios a estos manuales

Sin comentarios