Digi PortServer TS 8 Guía de usuario descargar pdf (Pagina 25)

Configuring A Hunt Group

Chapter 5 Configuring Ports for Modems 25

Example

set line range=2 baud=115200

3. Supply a set flow command that defines the flow control scheme required by the modem.

Example

In this example, ports 1 and 2 are configured for bidirectional modems.

set ports range=1-2 dev=mio

set line range=1-2 baud=115200

set flow range=1-2 ixon=off ixoff=off rts=on cts=on

Configuring A Hunt Group

A hunt group is a group of ports sharing one common IP address and differs from altip where one port has its

own unique IP address. A hunt group is desireable when you have many ports, but do not have the available IP

addresses or simply prefer to use one IP address for a group of ports. When a user telnets into the hunt group’s IP

address and the first port is busy, the user is seamlessly bumped to the next available port.

In configuring the PortServer for a hunt group, the port numbering must start higher than the total number of

PortServer serial ports available.

To configure a group of ports for a hunt group, do the following:

1. Enter the following command to create the hunt group:

set ports range=range group=port_number

2. Enter the following command to set the IP address for the hunt group:

set altip group=port_number ipaddress

Command Line Examples

The following example displays the configuration for 16 serial ports in a hunt group with their collective IP

address being 199.250.38.37.

set ports range=1-16 group=65

set altip group=65 ip=199.250.38.37

A user who telnets to this IP address is automatically connected to the first available hunt group port.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 99 100

Sin comentarios

Digi PortServer TS 8 Guía de usuario Pagina 25