Digi PortServer TS 8 Guía de usuario descargar pdf (Pagina 53)

In This Chapter

Chapter 10 Configuring IP Routing 53

Chapter 10 Configuring IP Routing

In This Chapter

This chapter describes how to configure IP routing. It discusses the following topics:

Configuring Static Routes..................................................................................................................34

Configuring Dynamic Routes Using RIP ..........................................................................................35

Configuring Proxy ARP.....................................................................................................................36

Configuring Static Routes

This section describes how to configure Digi One and PortServer TS 2/4 for static routes.

Related Information

See the set route command in the Digi One/PortServer TS Command Reference.

Procedure

To configure a static route over a PPP link, enter the following command:

set route net=addr mask=mask metric=hops wanname=interface gateway=gateway

where

• addr is either the IP address of a system to be reached over this route or the network address of the subnet that

is to be reached on this route

• mask is the mask to use for interpreting the IP address.

• metric is the number of hop to the destination

• interface is either ether if this route is over the Ethernet interface or the name of a user if the route is over a

PPP link

• gateway is the IP address of the device that is the next hop to the destination

Example: Route Using the Ethernet Interface

In this example, a route to a subnet is created over the Ethernet interface. Key features include the following:

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 99 100

Sin comentarios

Digi PortServer TS 8 Guía de usuario Pagina 53