Digi CM Guía de usuario descargar pdf (Pagina 142)

Configuring Port Clustering

142 Chapter 15

Slave authentication mode - To specify if your database is controlled by the

master unit, or locally by the slaves themselves.

Update Master on Changes -Automatically updates port name changes, port

settings, and user permission settings to the master unit. Generally, Update

Master on changes should be yes.

Connect to slave unit to change configuration - A quick access method to

connect to the slave.

Source port - This is the port number that you would access to get to the

slave on the master unit. The first slave port defaults to 7100 for the port

access menu and the port numbers increase according to the number of

ports on the Digi CM unit.

Destination port - The destination port is the corresponding port number on

the slave unit. On a 32-port slave unit, the destination port numbers range

from 7001 to 7032.

Protocol - The four options are N/A (not available), SSH, Telnet, and

RawTCP.

Base source port -If you choose not to use AutoConfig, you can set these

ports manually. Base source port is the first port number on a master unit.

By default the base source port on the master unit is 7001. The base

source ports extend the master’s ports via the slave ports. For example,

starting the base source port number with 7101 results in a 32-port unit

being numbered from 7101 to 7082. Port number 7100 is the port access

menu of the slave. If you configure the device manually, the port access

menu must also be configured separately.

Base destination port - The physical port numbers of the slave device.

Note: However, you can change the base source port number to another number and

the rest of the ports on the unit will be sequentially numbered from the base

source port.

1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 201 202

Sin comentarios

Digi CM Guía de usuario Pagina 142