Digi CM Guía de usuario descargar pdf (Pagina 62)

Configuring SMTP Alerts

62 Chapter 6

Configuring SMTP Alerts

Most SMTP servers check the sender’s email address with the host domain

name to verify the address as authentic. Consequently, when assigning an

email address for the device email address, any arbitrary username with the

registered hostname may be used. An example is username@company.com.

To configure the Digi CM unit for SMTP alerts, the following parameters are

required:

SMTP server - Use either the hostname or the IP address.

Device mail address - Specify the sender’s email address for the log and

alarm delivery.

SMTP mode - Specify the type of SMTP server to use.

Username and password - These fields are required for POP before SMTP

and SMTP with authentication servers.

To configure SMTP alerts on the Digi CM unit, do the following:

1. Access the web interface.

2. Under the Network heading, choose SMTP configuration.

3. Fill in the required fields. SMTP with authentication and POP before SMTP

require usernames and passwords.

4. Click Save & apply.

SNMP Information

Applications such as NMS (Network Management System) or an SNMP

browser can exchange information with the Digi CM unit and control actions to

the unit. The protocol functions defined for SNMP includes GET, SET, GET-

Next, GET-Bulk, and TRAP. Below are the definitions of the protocol functions

found in SNMP. Authentication, power on, and link up traps are supported.

The Digi CM unit

supports SNMP

authentication,

power on, and

link up traps.

Protocol Function

GET Queries a device for more information

SET Makes changes to a device’s state

GET-Next After an initial GET query, goes to the next value

GET-Bulk Retrieves tables of information and security functions

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 201 202

Sin comentarios

Digi CM Guía de usuario Pagina 62