Digi CM Guía de usuario descargar pdf (Pagina 43)

System Status and Port Logging

Chapter 4 43

6. Enter the contact email address.

7. Click Save & apply.

Viewing System Logs

The system logs can be viewed from the web interface on the System logging

page or from the location where they have been saved. The following table

lists the file locations of the system logs.

Configure Port Logging

If a serial port is configured for console server mode, the port logging feature

can be enabled. Port logging allows you to save serial data to the memory of

the Digi CM unit, a compact-flash card, a syslog server, or to an NFS server. If

the memory is used for port logging, all data is cleared when the system’s

power is turned off.

You can also define alarm keywords for each serial port and send email alerts

or SNMP traps to enable unattended serial data monitoring. The following

steps configure a serial port for port logging in console server mode.

1. Access the web interface.

2. Under the Serial port heading, click Configuration.

3. Choose All or the Individual port, and then

Port logging.

4. Configure the settings:

Logging direction - Specify what to log:

• Server – only server output,

• User – only user output,

• Both with/without arrows – server and user output with/without direc-

tional arrows.

• Default: server output.

Security advice: When logging user output passwords will be saved into

the log file!

Port log to SYSLOG server - Enable to store port logs to a SYSLOG server

Port logging filename - Options are to specify your own or use the port title

for the port log filename

System Logfile

Log Storage File Location

Digi memory /tmp/logs

Compact-flash card /mnt/flash/logs

Syslog server must be viewed on the syslog server

NFS server /mnt/nfs/logs

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 201 202

Sin comentarios

Digi CM Guía de usuario Pagina 43