Digi CM Guía de usuario descargar pdf (Pagina 51)

Configuring Ports

Chapter 5 51

\x1b\x20test\x0D <ESC><Space>test<CR>

\x1B\x20\x74\x65\x73\x74\x0d <ESC><Space>test<CR>

Detected OS - Displays the result of the Active or Passive detection process.

Device detection method - If Active is selected a probe string is periodically sent

to the device and the response is analyzed. If Passive is selected, the port

logging is parsed to determine the device name and the OS.

Detection initiation - Active only if automatic detection is Enabled. Periodically or

If new device is detected are the choices in the drop down menu. If

Periodically is selected, the probe string is sent once every n minutes to the

device while no connection is active to the serial port. When If new device is

detected is selected, the probe string is only sent if a change on the DSR

signal on the serial port is detected. Normally a device will activate the DSR

signal if the serial port becomes active.

Detection delay - The delay before the first active detect process is started and

between active detections.

5. Click Save & apply.

Apply all Ports Settings

The Digi CM unit supports managing all ports simultaneously. If changes are

made to the page “all ports”, they are automatically applied to all ports. You

can choose to exclude ports from this feature.

To enable/disable this feature for a port:

1. Access the web interface.

2. Under the Serial Port heading, click Configuration.

3. Choose an individual port > Host mode configuration.

4. Select Enable or Disable from the drop down menu.

5. Click Save to flash and continue with other configurations or click Save & apply.

Note: When changing a parameter for all ports, all settings of the complete page are

applied to all ports.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 201 202

Sin comentarios

Digi CM Guía de usuario Pagina 51